Town Car V8-4.6L VIN W (1997)
Cruise Control Servo Cable: Adjustments
1. Remove adjuster clip from actuator cable adjuster at accelerator cable bracket.
2. Make sure throttle is in fully closed position.
3. Pull on speed control actuator cable to take up slack, then back off at least one notch so there is approximately 3 mm (0.118 inch) of slack in the
speed control actuator cable.
CAUTION: The speed control actuator cable must not be pulled tight, otherwise speed control may not operate properly.
4. Insert speed control actuator cable retaining clip and snap into place.
5. Check that throttle linkage operates freely and smoothly.
