Town Car V8-4.6L VIN W (1997)
WARNING: Place air bag module on bench with trim cover facing up to avoid accidental deployment and possible personal injury.
6. Remove two remaining passenger air bag module retaining screws, disconnect electrical connector and remove passenger side air bag module by
pushing on passenger side air bag module from inside panel. Do not handle passenger side air bag module by grabbing edges of deployment doors.
INSTALLATION
NOTE: Fill out and return air bag traceability postcard for new air bag with Vehicle Identification Number (VIN) and note diagnostic trouble code.
1. Connect electrical connector to passenger side air bag module and position passenger side air bag module in instrument panel.
2. Install two upper retaining screws. Tighten to 2.1-2.9 Nm (19-25 lb in).
3. Install two lower module retaining bolts. Tighten to 7.6-10.4 Nm (68-92 lb in).
4. Return glove compartment to correct position.
5. Install instrument panel finish panel.
6. Reconnect battery ground cable.
7. Prove out air bag system.
8. Reprogram radio frequencies and set clock.
