Town Car V8-4.6L VIN W (1997)
Parts Replacement Chart (Typical)
5. Install attachment parts in proper sequence shown in the applicable illustration. Tighten the replacement bolt to 34-46 Nm (25-33 lb ft). Original
parts are to be replaced with service parts indicated in Parts Replacement Chart.
6. When servicing a multiple belt and attachment, install nut (382599-S100) to the bolt in the tunnel area from the underside of the rear floor pan.
Tighten to 34-46 Nm (25-33 lb ft).
Seat Belt Without Anchor Plate Thread Damage
The seat and shoulder safety belts are factory-installed in their proper locations. If the belts are removed for any reason, they should be re-installed. The
7/16-inch x 20 Torx(r) head anchor bolts must be hand-started and then tightened to 34-46 Nm (25-33 lb ft).
1. Remove damaged bolt from anchor reinforcement and discard.
2. Install a new bolt by hand. Refer to the Parts Replacement Chart for part number. Tighten to 34-46 Nm (25-33 lb ft).
Shoulder Strap Adjuster With Stripped Weld Nuts, Front Seat
NOTE: If the two hex-head attaching bolts on the shoulder safety belt height adjuster are not stripped, install the shoulder safety belt height adjuster to
the body structure as described in Removal and Installation. It the front seat shoulder strap adjuster attaching bolts are stripped, replace the shoulder
safety belt height adjuster and install it to the body structure.
