Town Car V8-4.6L VIN W (1997)
1. With the B-pillar interior trim panel removed, drill out the damaged threads in the upper B-pillar structure using a 1/2 inch drill.
2. Apply a suitable lubricant to the threads of an M14 x 1.5 tap and tap new threads.
NOTE: After each rotation, back tap off slightly to remove new cuttings and be sure to blow out any chips before performing Step 3.
3. Select a thread insert and hand-screw it into the retapped hole until it is slightly below the surface of the hole.
NOTE: The drive "kees" on the insert will act as an automatic stop.
4. After installation of the thread insert, use a 12-ounce hammer to lightly tap an installation tool several times to drive down the insert "kees".
