Town Car V8-4.6L VIN W (1997)
REMOVAL
1. From inside luggage compartment, disconnect two-pin sensor connector from wiring harness and push sensor wire through hole in floor.
2. From below vehicle, remove sensor wire from routing bracket located on top of rear axle housing and remove steel clip holding sensor wire and
brake tube against rear axle housing.
3. Remove screw from clip holding sensor wire and brake tube to bracket on rear axle housing.
4. Remove rear brake anti-lock sensor to rear wheel disc brake adapter retaining bolt and remove rear brake anti-lock sensor.
INSTALLATION
1. Insert rear brake anti-lock sensor into rear wheel disc brake adapter and install retaining bolt. Tighten to 5-6 Nm (45-53 inch lbs.).
2. Attach clip holding rear brake anti-lock sensor and brake tube to bracket on rear axle housing and secure with screw. Tighten to 5-6 Nm (45-53
inch lbs.).
3. Install steel clip around rear axle housing tube that holds sensor wire and brake tube against rear axle housing tube. Push spool-shaped grommet
into clip located on top of axle carrier housing.
4. Push sensor wire connector up through hole in floor and seat large round grommet into hole.
5. Connect sensor two-pin connector to wiring harness inside luggage compartment.
