Town Car V8-4.6L VIN W (1997)
Ride Height Sensor: Service and Repair
REMOVAL
1. Hoist vehicle. Suspension must be at full rebound.
WARNING: TURN AIR SUSPENSION SWITCH OFF TO PREVENT VEHICLE DAMAGE OR PERSONAL INJURY.
2. Disconnect electrical connector.
3. Disconnect bottom and then top end of air suspension height sensor from ball studs by depressing spring clip and pulling air suspension height
sensor away from ball stud.
NOTE: Before removing air suspension height sensor from ball studs, observe depth of studs in air suspension height sensor.
INSTALLATION
1. Connect top and then bottom end of air suspension height sensor to ball studs. Make sure that ball studs are fully seated in air suspension height
sensor ball stud retainer housings.
2. Connect air suspension height sensor electrical connector.
3. Lower vehicle.
4. Turn air suspension switch ON.