Town Car V8-4.6L VIN W (1997)
INSTALLATION
1. Check solenoid O-rings for abrasion or cuts. Replace solenoid wrings as required. Lightly grease O-ring area of solenoid and larger solenoid
housing solenoid O-ring with Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification
ESE-M1C171-A.
2. Insert solenoid valve into air spring end cap and rotate clockwise to third stop, push into second stop, then rotate clockwise to first stop.
3. Install air spring solenoid retainer.
4. Inspect wire harness connector and make sure rubber gasket is in place at bottom of connector cavity.
5. Connect air line and electrical connector.
6. install heat shield.
7. Lower hoist as required, but do not apply a load to the suspension.
8. Refill air spring(s) as follows using Functional Test DTC 26.
