Town Car V8-4.6L VIN W (1997)
NOTE: Allow a minimum of five minutes for glass primer to dry.
10. Apply an even bead of urethane WSB-M2G316-B around entire sheet metal pinch weld next to back window moulding retaining leg. The bead
should be triangular in shape, 16 mm (0.625 inch) high and 8 mm (0.33 inch) at base.
NOTE
-
Leave a door window slightly open until adhesive is cured.
-
Apply new urethane on top of existing material on pinch weld.
11. Install back window assembly onto vehicle, taking care to align marks on glass and body. This must be done before adhesive skins over.
CAUTION: Use only urethane for service of air and water leaks in urethane-set back windows. When replacing urethane-Installed glass parts, do
not drive the vehicle until the urethane has cured. At temperatures above 13°C (55°F) and relative humidities above 50%, adequate cure time is
typically 12 to 24 hours (less at higher temperatures and lower humidities). See detailed instructions provided by the urethane manufacturer.
Inadequate or improper curing may adversely affect the retention of the back window.
12. Tuck finisher strip on window moulding along the side under the ditch moulding.
13. Reconnect antenna and rear window defroster wires.
14. Remove spacer and install headliner. Install all garnish mouldings.
15. Install rear package tray trim panel.
16. Check installation for air and water leaks in urethane seal.
