Town Car V8-4.6L VIN W (1997)
Wiper Motor: Testing and Inspection
Use Rotunda Digital Volt-Ohmmeter 014-00407 or equivalent.
CAUTION: Do not roughly handle any windshield wiper motor when diagnosing wiper operations, as it may damage the magnets and make the
windshield wiper motor inoperative. Rough handling of new replacement windshield wiper motors may also damage the magnets.
1. To test the windshield wiper motor on the vehicle, disconnect the windshield wiper motor from the windshield wiper assembly and disconnect the
electrical connector.
2. Connect the green lead from Rotunda Alternator, Regulator, Battery and Starter Tester 010-00725 or equivalent to the battery positive (+) post.
3. Connect the positive (red) lead from the tester to the common brush terminal.
4. Connect a ground first to the low-speed connection and then to the high-speed connection at the connector plug as shown.
The current draw should not exceed 3.5 amps at low-speed and 5.5 amps at high-speed.
