Zephyr V6-3.0L VIN 1 (2006)
Seat Heater Control Module: Service and Repair
Climate Controlled Seat Module
CLIMATE CONTROLLED SEAT MODULE
Worldwide Diagnostic System (WDS)
Special Tool(s)
Removal
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a SRS component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the front seat and depower the supplemental restraint system (SRS).
2. Remove the dual climate controlled seat module (DCSM) from the cushion electrical bracket.
-
Release the locking wedges and disconnect the 3 DCSM electrical connectors.
-
Remove the 2 rivets and DCSM.
Installation
1. Install the dual climate controlled seat module (DCSM) to the seat.
-
Position the DCSM to the electrical bracket and install 2 new rivets.
-
Connect the 3 DCSM electrical connectors and locking wedges.
2. Install the front seat and repower the SRS. Do not prove out the SRS at this time.
3. Carry out the Zero Seat Weight Test and prove out the SRS. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component Tests
and General Diagnostics/Zero Seat Weight Test
4. Reflash the DCSM with the latest operational software.
