Zephyr V6-3.0L VIN 1 (2006)
3.0L. Engine
Removal and Installation
All vehicles
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power
steering components can result.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the power steering pressure line banjo bolt and disconnect the line from the power steering pump.
^
Discard the bolt and seals.
^
To install, tighten to 35 Nm (26 ft. lbs.).
2.3L engine
3. Remove the power steering pressure line bracket-to-sub frame bolt.
^
To install, tighten to 9 Nm (80 inch lbs.).
3.0L engine
4. Remove power steering line-to-power steering reservoir bolt.
^
Detach the electrical harness retainer from the power steering pressure line bracket.
^
To install, tighten to 9 Nm (80 inch lbs.).
5. Remove the power steering pressure line bracket-to-RH cylinder head bolts.
All vehicles
6. Remove the power steering pressure line bracket-to-steering gear bolt.
^
To install, tighten to 9 Nm (80 inch lbs.).
7. Remove the power steering pressure line banjo bolt from the power steering gear and remove the power steering pressure line.
^
Discard the bolt and seals.
^
To install, tighten to 35 Nm (26 ft. lbs.).
8. CAUTION: A new bolt and new seals must be installed any time the power steering pressure line is disconnected from the power steering pump
and/or the steering gear.
To install, reverse the removal procedure.
9. Fill the power steering system.
