Zephyr V6-3.0L VIN 1 (2006)
1. CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the
tube.
NOTE: Apply clean engine oil to O-ring seals.
Release the lock tab and install the coupling onto the fitting.
2. Apply the lock tab into the LATCHED position.
Disconnect - Type III
WARNING:
-
Do not carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable vapors
are always present and can ignite. Failure to follow these instructions may result in personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions can
result in personal injury.
-
This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to
follow these instructions may result in personal injury.
CAUTION:
-
If the liquid or vapor tube is damaged (torn, holes or delaminated), the affected tube assembly must be replaced with a new tube
assembly. Do not use aftermarket sleeving. Do not re-adhere loose sleeving material.
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube. Apply clean engine oil to the end of the tube before inserting the tube into the
connector.
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is therefore essential that absolute cleanliness
is observed when working with these components. Always install blanking plugs to any open orifices or tubes.
1. Release the fuel system pressure.
2. Disconnect the battery ground cable.
