Zephyr V6-30L VIN 1 (2006) - Seat Occupant Sensor Module Service and Repair
NOTE: Make sure the OCS rail shield is seated correctly on the OCS rail. Align the locator pin to the shield and attach the OCS rail shield rear
tab to the OCS rail.
Position the OCS rail shield on the OCS rail. Then position the OCS rail and shield on the seat track while noting the correct installation of the
OCS rail locator pin into the seat track.
2. NOTE: To make sure of correct installation, the OCS rail bolts must be installed in the sequence shown.
While holding the OCS rail and shield firmly in position, install the OCS rail front mounting position rear bolt.
-
Tighten to 25 Nm (18 lb-ft).
3. While still holding the OCS rail and shield firmly in position, install the OCS rail front mounting position front bolt.
-
Tighten to 25 Nm (18 lb-ft).
4. Move the seat to the forward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
5. Install the 2 rear OCS rail bolts.
-
Tighten to 25 Nm (18 lb-ft).
6. Connect the OCS rail electrical connector.
