Zephyr V6-3.0L VIN 1 (2006)
7. Center the seat track to the seat cushion pan.
-
If equipped with a power seat track, apply power and ground to the pins shown.
8. If equipped, connect the power seat track motor electrical connector.
Seat receiving a new OCS rail
9. Install the rearward seat riser and the 2 bolts.
-
Tighten to 25 Nm (18 lb-ft).
10. Install the forward seat riser and bolt.
-
Tighten to 25 Nm (18 lb-ft).
Outboard OCS rail
11. Attach the cushion side shield.
-
Position the rear retainer clip on the cushion side shield through the hole in the backrest trim cover flap and attach it to the rear edge of the
seat.
12. If equipped, install the spring clip and the manual recliner handle.
13. If equipped, install the manual lumbar control knob.
All OCS rails
14. Install the passenger seat and repower the supplemental restraints system (SRS). Do not prove out the SRS at this time.
15. Carry out the appropriate procedure after installation of an OCS system component.
-
If installing the original OCS system component, carry out the Zero Seat Weight Test and prove out the SRS. See: Air Bag Systems/Testing
and Inspection/Component Tests and General Diagnostics/Zero Seat Weight Test
-
If installing a new OCS system component, carry out the System Reset procedure and prove out the SRS. See: Air Bag Systems/Testing and
Inspection/Component Tests and General Diagnostics/System Reset
