Zephyr V6-3.0L VIN 1 (2006)
Knock Sensor: Service and Repair
KNOCK SENSOR (KS)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. If equipped, remove the 7 screws and the underbody cover.
4. Disconnect the knock sensor (KS) electrical connector.
5. Remove the bolt and the KS.
-
To install, tighten to 20 Nm (15 lb-ft).
6. To install, reverse the removal procedure.