Zephyr V6-3.0L VIN 1 (2006)
2. Remove the parking brake cable bracket bolt and position the parking brake cable aside.
^
To install, tighten to 10 Nm (89 inch lbs.).
3. If equipped, detach the wheel speed sensor harness from the trailing arm.
4. Using a suitable jack, raise the trailing arm.
5. WARNING: The spring is under extreme compression, care must be taken at all times. Failure to follow this instruction may result in
personal injury.
Remove and discard the lower arm outboard bolt.
^
To install, tighten to 101 Nm (74 ft. lbs.) with the suspension at the bushing fastener tightening position.
6. Remove and discard the upper arm outboard bolt.
^
To install, tighten to 110 Nm (81 ft. lbs.) with the suspension at the bushing fastener tightening position.
7. Carefully lower the trailing arm and remove the jack.
8. Remove and discard the shock absorber lower bolt and flag nut.
^
To install, tighten to 115 Nm (85 ft. lbs.) with the suspension at the bushing fastener tightening position.
9. Remove and discard the toe link outboard bolt.
^
To install, tighten to 110 Nm (81 ft. lbs.) with the suspension at the bushing fastener tightening position.
10. Remove and discard the 2 trailing arm forward bolts and remove the trailing arm.
^
To install, tighten to 133 Nm (98 ft. lbs.).
11. CAUTION: Before tightening any suspension bushing fasteners, the suspension must be at the bushing fastener tightening position. Use a
suitable jack to raise the suspension until the distance between the center of the hub and the lip of the fender is equal to 395 mm (15.55 inch).
To install, reverse the removal procedure.
12. Check and, if necessary, align the rear end.
