Zephyr V6-3.0L VIN 1 (2006)
14. While holding the insulation away from the bulkhead, remove the 2 selector lever cable bracket nuts and remove the selector lever cable.
Installation
All vehicles
1. Install the selector lever cable and Install the 2 nuts.
^
Tighten to 8 Nm (71 inch lbs.).
2. Position back the RCM wiring harness and install the fasteners on the studs.
3. Install the RCM. For additional information, refer to Air Bag Systems.
4. Install the selector lever cable in the selector lever housing.
5. NOTE: Center console removed for clarity.
