3 L4-2.0L (2007)
Engine Oil Control Valve: Testing and Inspection
OIL CONTROL VALVE (OCV) INSPECTION [LF, L3]
Coil Resistance Inspection
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
3. Disconnect the oil control valve connector.
4. Measure the resistance between terminals A and B using an ohmmeter.
-
If not as specified, replace the oil control valve.
Specification
6.9 - 7.9 ohms [20°C (68°F)]
5. Connect the oil control valve connector.
6. Install the plug hole plate.
7. Connect the negative battery cable.
Spool Valve Operation Inspection
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
3. Disconnect the oil control valve connector.
4. Remove the oil control valve.
5. Verify that the spool valve in the oil control valve is in the maximum valve timing retard position as indicated in the figure.
-
If not as specified, replace the oil control valve.
6. Verify that the battery is fully charged.
-
If not as specified, recharge the battery.
