3 L4-2.0L (2007)
5.
Remove the front seat belt buckle bolt, then remove the buckle from the seat.
6.
Install the new seat belt buckle and bolt.
Tightening torque: 40-50 Nm (4.1-5.0 kgfm, 30-36 ft-lbf)
7.
Route the wire harness for the seat belt switch like it was before.
8.
Install the wire harness in the clip and zip tie the wire harness in the two places where it was previously attached.
9.
Connect the seat belt switch connector to the front seat connector.
NOTE:
Connect the front seat connector to the seat frame if it was removed.
10.
Install the front seat(s). Refer to MS3 online instructions or Workshop Manual section 09-13 FRONT SEAT REMOVAL/INSTALLATION.
NOTE:
If the passenger's seat was removed, perform the Seat Weight Sensor Calibration.
11.
Verify repair.
^
Driver's side: With the driver's seatbelt buckle unbuckled, turn the ignition switch ON and verify seatbelt warning light is on. Then buckle the
driver's seatbelt and verify warning light turns off.
^
Passenger's side: With the front passenger's seatbelt buckle unbuckled, turn the ignition switch ON and verify passenger's air bag off indicator
turns on, then off. Next, buckle the passenger's seatbelt and verify passenger's air bag off indicator turns on and stays on.
PART(S) INFORMATION
