3 L4-2.0L (2007)
8. Install the battery duct and battery cover.
Off-Vehicle Inspection
Warning: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.
1. Remove the control valve body.
2. Remove the coupler component.
3. Place the TFT sensor and a thermometer in ATF as shown in the figure, and heat the ATF gradually.
4. Measure the resistance between the terminals of the TFT sensor.
^
If there is any malfunction, replace the TFT sensor.
5. Install the coupler component.
6. Install the control valve body
