3 L4-2.3L (2004)
-
Pulley and belt for runout and contact
-
Leakage of engine oil
-
Ignition timing, idle speed, and amount of CO and HC.
-
Engine-driven accessories operation
Crankshaft Pulley Lock Bolt Removal Note
1. Remove the cylinder block lower blind plug.
2. Install the SST.
3. Turn the crankshaft clockwise the crankshaft is in the No. 1 cylinder TDC position (until the balance weight is attached to the SST).
4. Hold the crankshaft pulley using the SSTs.
No.3 Engine Mount Removal Note
1. Install the suitable wood slabs between the front fender panel and apron reinforcement upper.
Note:
-
Wood slab height
4Door: approx. 35 mm [1.38 inch)
5Door: approx. 60 mm [2.36 inch)
-
Cut the wood slab into two piece and insert.
