mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Emission - MIL ON/Multiple Fuel/Emissions DTC's Set|Page 3476 > < Emissions - MIL ON/DTC P0441 Set|Page 3471
Page 1
background image

Canister Purge Solenoid: Customer Interest
Emission - MIL ON/Multiple Fuel/Emissions DTC's Set

TSB: 01-052/06

2004-2006 MAZDA3, MAZDA6 - MIL ILLUMINATION, P0171 / P0172 / P0441 / P0442 / P0455 / P0456 / P2177 / P2178 / P2187 / P2188

NOTE:

This bulletin replaces 01-025/05. Please update your records accordingly.

BULLETIN NOTE

This bulletin supersedes the previous bulletin 01-025/05, issued on 09/21/05. The PART(S) and WARRANTY INFORMATION has been revised.

APPLICABLE MODEL(S)/VINS

2004 - 2006 MAZDA3

2004 - 2006 MAZDA6 2.3L

DESCRIPTION

Some vehicles may experience MIL illumination with DTC P0171 / P0172 / P0441 / P0442 / P0455 / P0456 /P2177 / P2178 / P2187 / P2188 stored in
PCM memory.

P0171: Fuel trim system too lean. (Federal Spec.)

P0172: Fuel trim system too rich. (Federal Spec.)

P0441: Evaporative emission control system incorrect purge flow.

P0442: Evaporative emission control system leak detected (small leak)

P0455: Evaporative emission control system leak detected (gross leak)

P0456: Evaporative emission control system leak detected (very small leak) (Calif. Spec.)

P2177: Fuel system too lean at off idle. (Calif. Spec.)

P2178: Fuel system too rich at off idle. (Calif. Spec.)

P2187: Fuel system too lean at idle. (Calif. Spec.)

P2188: Fuel system too rich at idle. (Calif. Spec.)

This may be due to a stuck opened purge solenoid valve.

Customers having this concern should have their vehicle repaired using the following repair procedure.

REPAIR PROCEDURE

1.

Verify concern.

2.

Capture freeze frame data then clear all DTCs.

3.

Inspect the airflow sealing of the purge solenoid valve by using the Purge Solenoid Test Cap (MT04-F2-001) and vacuum pump below. Apply
vacuum to at least 20". The vacuum reading should hold indefinitely.

^

If the vacuum reading does not hold, replace the purge solenoid valve.

^

If the vacuum reading holds, go to next step.

NOTE:

Make sure the Purge Solenoid Test Cap (MTO4-F2-001) does not leak at the fitting before testing purge solenoid valve.

4.

Cycle purge solenoid valve a few times to check for intermittent sealing issues. Refer to page 01-16-14 Airflow Inspection of 2004 Mazda3

Emission - MIL ON/Multiple Fuel/Emissions DTC's Set|Page 3476 > < Emissions - MIL ON/DTC P0441 Set|Page 3471