3 L4-2.3L (2004)
Leak Detection Pump: Service and Repair
EVAPORATIVE EMISSION (EVAP) SYSTEM LEAK DETECTION PUMP REMOVAL/INSTALLATION
1. Remove the charcoal canister protector.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal
4. Verify that the rear wheel alignment is within the specification.
EVAP System Leak Detection Pump Removal Note
1. Support the rear crossmember using a transmission jack.
2. Remove the rear wheels.
3. Disconnect the ABS wheel-speed sensor wiring harness connector.
