3 L4-2.3L (2004)
15.
Remove ABS dust cover by tapping lightly with hammer and chisel. Be careful not to damage drive shaft.
NOTE:
Do not reuse the ABS dust cover because the washer will replace it. The washer has two purposes: (1) to eliminate the clicking noise and (2) to
take the place of the ABS rotor dust cover.
16.
Polish drive shaft surface where it contacts wheel hub. Use #) 240 sand paper (or equivalent) sourced locally. Surface should be smooth to the
touch. Degrease surface as a final cleaning.
17.
Install special washer, with protruded surface (black side) facing driveshaft. Make sure drive shaft fits inside washer protrusion.