Keyless Beeper Removal/Installation Procedure - Page 6155
Keyless Entry Module: Service and Repair
Keyless Control Module Removal/Installation
KEYLESS CONTROL MODULE REMOVAL/INSTALLATION
1. If the keyless control module is replaced, always perform the following procedure.
-
Vehicles with immobilizer system
-
Keyless Control Module Configuration See: Testing and Inspection/Programming and Relearning/Keyless Control Module Configuration
-
Immobilizer System-related Parts Programming [No.4 Programming Procedure Due to Keyless Control Module Replacement] See:
Testing and Inspection/Programming and Relearning/Advanced Keyless Entry And Push Button Start System
-
Vehicles without immobilizer system
-
Keyless Control Module Configuration See: Testing and Inspection/Programming and Relearning/Keyless Control Module Configuration
-
Advanced Key Id Code Registration See: Testing and Inspection/Programming and Relearning/Advanced Key ID Code Registration
-
Steering Lock Unit Id Code Registration See: Testing and Inspection/Programming and Relearning/Steering Lock Unit ID Code
Registration
2. Disconnect the negative battery cable.
3. Remove the following parts:
a. Passenger-side front scuff plate See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate
Removal/Installation
b. Passenger-side front side trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim
Removal/Installation
c. Grove compartment See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair
d. Passenger-side lower panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Lower Panel Removal/Installation
4. Remove in the nuts.
5. Disconnect the connector.