3 L4-2.5L (2010)
KEYLESS RECEIVER INSPECTION [KEYLESS ENTRY SYSTEM]
1. Remove the following parts:
a. Front scuff plate (LH) See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate Removal/Installation
b. Front side trim (LH) See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim Removal/Installation
c. Upper panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Upper Panel Removal/Installation
d. Shift knob (MTX) See: Transmission and Drivetrain/Manual Transmission/Transaxle/Shifter M/T/Service and Repair
e. Selector lever knob (ATX) See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and Repair/Automatic
Transaxle Shift Mechanism Removal/Installation
f.
Shift panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Shift Panel Removal/Installation
g. Side wall See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Side
Wall Removal/Installation
h. Console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Console Removal/Installation
2. Set the hood release lever out of the way. See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release/Service and Repair
3. Remove the lower panel. (driver-side) See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal
and Replacement/Lower Panel Removal/Installation
4. Measure the voltage according to the terminal voltage table.
-
If the voltages cannot be verified as indicated in the terminal voltage table, inspect the parts under "Inspection item (s)".
-
If the system does not work normally even though the parts or related wiring harnesses do not have any malfunction, replace the keyless
receiver.
5. Disconnect the negative battery cable.
Terminal Voltage Table (Reference)
Terminal Voltage Table (Reference)
