3 L4-2.5L (2010)
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
-
Select the "Module Programming".
3. Then, select items from the screen menu in the following order.
1
Select "Programmable Module Installation".
2
Select "MID".
4. Perform the configuration according to the directions on the screen.
5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
-
If a DTC (s) is detected, perform the applicable DTC inspection. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Descriptions/DTC Table [Multi Information Display]
Multi Information Display Maintenance Monitor Operation Procedure
MULTI INFORMATION DISPLAY MAINTENANCE MONITOR OPERATION PROCEDURE
-
The maintenance monitor displays a notification when a tire rotation or periodic inspection period approaches to inform the driver.
-
The notification timing can be performed according to either the remaining travel distance or remaining days by performing the following
procedure:
-
Notification timing setting method
-
Reset method
-
Notification display ON/OFF setting method
-
Remaining distance and number of days information is not erased even if the battery is disconnected.
-
If the multi information display is repaired or replaced, it is possible that the remaining distance and number of days information will be erased.
Notification Timing Setting Method
CAUTION:
-
Because the time information is reset after the negative battery cable is disconnected, the regular inspection period cannot be set using days. If the
time information is reset, move the vehicle outdoors where reception of time information via GPS is possible.
-
After verifying that the time is displayed on the multi information display, perform the day-setting procedure for the regular inspection period.
-
Do not place objects around the GPS antenna, otherwise the GPS signal cannot be received.
1. Press the INFO SWITCH to display the SETTINGS menu.
2. When the MAINTENANCE menu is displayed, press the ENTER switch.
3. Select TIRE ROTATION or SERVICE DUE and press the ENTER switch.
4. Select SET and press the ENTER switch.