3 L4-2.5L (2010)
Keyless Entry Receiver: Component Tests and General Diagnostics
Advanced Keyless Entry And Push Button Start System
KEYLESS RECEIVER INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
1. Remove the following parts:
a. Front scuff plate (LH) See: Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate Removal/Installation
b. Front side trim (LH) See: Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim Removal/Installation
c. Upper panel See: Interior Moulding / Trim/Console/Service and Repair/Upper Panel Removal/Installation
d. Shift knob (MTX) See: Transmission and Drivetrain/Manual Transmission/Transaxle/Shifter M/T/Service and Repair
e. Selector lever knob (ATX) See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and Repair/Automatic
Transaxle Shift Mechanism Removal/Installation
f.
Shift panel See: Interior Moulding / Trim/Console/Service and Repair/Shift Panel Removal/Installation
g. Side wall See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Side Wall
Removal/Installation
h. Console See: Interior Moulding / Trim/Console/Service and Repair/Console Removal/Installation
2. Set the hood release lever out of the way. See: Doors, Hood and Trunk/Hood/Hood Latch Release/Service and Repair
3. Remove the lower panel. (driver-side) See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Lower Panel Removal/Installation
4. Measure the voltage according to the terminal voltage table.
-
If the voltages cannot be verified as indicated in the terminal voltage table, inspect the parts under "Inspection item (s)".
-
If the system does not work normally even though the parts or related wiring harnesses do not have any malfunction, replace the keyless
receiver.
5. Disconnect the negative battery cable.
Terminal Voltage Table (Reference)
Terminal Voltage Table (Reference)
Keyless Entry System
