3 L4-2.5L (2010)
Memory Positioning Module: Service and Repair
POSITION MEMORY CONTROL MODULE REMOVAL/INSTALLATION
WARNING:
-
Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read
the service warnings before handling a front seat (with built-in side air bag). See: Restraint Systems/Air Bag Systems/Service Precautions/Air Bag
System Service Warnings
CAUTION:
-
After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the
slide adjuster may be damaged after the front seat is installed.
-
Verify that there are no malfunctions in the sliding mechanism after installing a front seat.
-
When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the
seat.
1. Operate the power seat switch and move the seat cushion forward and upward.
2. Turn the ignition switch to the LOCK position.
3. Disconnect the negative battery cable and wait 1 min or more.
4. Remove the driver-side front seat. See: Seats/Service and Repair/Removal and Replacement
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
