3 L4-2.5L (2010)
Seat Track: Service and Repair
FRONT SEAT RAIL GUIDE COVER REMOVAL/INSTALLATION
WARNING:
-
Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read
the service warnings before handling a front seat (with built-in side air bag). See: Restraint Systems/Air Bag Systems/Service Precautions/Air Bag
System Service Warnings
CAUTION:
-
After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the
slide adjuster may be damaged after the front seat is installed.
-
Verify that there are no malfunctions in the sliding mechanism after installing a front seat.
-
When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the
seat.
Vehicles Without Power Seat System
1. Switch the ignition to off.
2. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
3. Disconnect the negative battery cable and wait 1 min or more.
4. Remove the front seat. See: Service and Repair/Removal and Replacement
5. Remove the screw, clip and disengage the tab, remove the front seat rail guide cover.
6. Install in the reverse order of removal.
Vehicles With Power Seat System
1. Switch the ignition to off.
2. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
3. Disconnect the negative battery cable and wait 1 min or more.
4. Remove the front seat. See: Service and Repair/Removal and Replacement
5. Remove the screws and disengage the tab, remove the front seat rail guide cover.
