3 L4-2.5L (2010)
Lateral runout inspection
1. To secure the disc plate and the hub, insert the washer (thickness 10 mm {0.39 in}, inner diameter more than 12 mm {0.47 in}) between each hub
bolt and the hub nut, then tighten all the hub nuts.
NOTE:
-
The component parts of the SST (49 B017 001 or 49 G019 003) can be used as a suitable washer.
2. After tightening all the hub nuts to the same torque, put the dial gauge on the friction surface of the disc plate 10 mm {0.39 in} from the disc plate
edge.
3. Rotate the disc plate one time and measure the runout.
Rear disc plate runout limit
-
0.05 mm {0.002 in}
Thickness variation inspection
1. Clean the disc plate-to-pad friction surface using a brake cleaner.
2. Measure the points indicated in the illustration using a caliper (micrometer).
