3 L4-2.5L (2010)
-
If not within the specification, inspect for the cause and repair or replace if necessary.
NOTE:
-
The oil pressure can vary with oil viscosity and temperature.
Oil pressure (reference value) [oil temperature: 100 °C {212 °F}]
-
LF: 234-521 kPa {2.39-5.31 kgf/cm2, 34.0-75.5 psi} [3,000 rpm]
-
L5: 395-649 kPa {4.03-6.61 kgf/cm2, 57.3-94.1 psi} [3,000 rpm]
9. Stop the engine and wait until it is cools.
10. Disconnect the negative battery cable.
11. Remove the SSTs.
CAUTION:
-
Be sure there is no sealant between 1.0-2.0 mm {0.040-0.078 in} from the end of the oil pressure switch to prevent a possible operation
malfunction.
12. Apply silicone sealant to the oil pressure switch threads as shown in the figure.
CAUTION:
-
Install the oil pressure switch before the applied sealant starts to harden.
13. Install the oil pressure switch.
Tightening torque
-
12-18 Nm {123-183 kgf-cm, 107-159 in-lbf}
14. Connect the negative battery cable.
15. Start the engine and confirm that there is no oil leakage.
-
If there is oil leakage, repair or replace the applicable part.
16. Install the aerodynamic under cover No.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
17. Install the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
