3 L4-2.5L (2010)
6. Insert the SST quick release connector into the fuel pipe until a click is heard.
7. Verify that the quick release connector is firmly connected by pulling it by hand.
8. Start the fuel pump using the following procedure.
Using M-MDS
-
Connect the negative battery cable. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
-
Connect the M-MDS to the DLC-2.
-
Using the simulation function "FP", start the fuel pump. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/On-Board Diagnostic Test
Without using M-MDS
-
Remove the fuel pump relay.
CAUTION:
-
Short the specified terminals because shorting the wrong terminal of the relay and fuse block may cause malfunctions.
-
Using a jumper wire, short fuel pump relay terminals C and D in the relay and fuse block.
-
Connect the negative battery cable and operate the fuel pump.
9. Operate the fuel pump for 10 s.
10. Measure the fuel line pressure.
-
If not within the specification, inspect the following:
If it less than the specification:
-
Fuel pump unit
-
Fuel line for clogging or leakage
If it exceeds the specification: