3 L4-2.5L (2010)
CAUTION:
-
When installing the evaporator temperature sensor without newly replacing the evaporator, assemble the evaporator temperature sensor with the
installation position slid to the left of the previous position by 1 line. If the evaporator temperature sensor is assembled to the previously installed
position, it may not function due to poor contact of the fin surface with the sensor detection area caused by fin deformation.
NOTE:
-
Newly replace an evaporator in which the evaporator temperature sensor cannot be correctly positioned.
Adhesive Polyurethane (2) Assembly Note
1. Wrap the low-pressure side of the evaporator pipe with insulator.
2. Assemble the adhesive polyurethane as shown in the figure.
