3 L4-2.5L (2010)
-
If the center panel is removed forcefully it could result in damage to the hazard warning switch connector wiring harness. Carefully pull the
center panel until clips B are pulled out.
5. Remove the center panel.
6. Disconnect the hazard warning switch connector.
7. Install in the reverse order of removal.
Dashboard Removal/Installation
DASHBOARD REMOVAL/INSTALLATION
1. Set the air intake mode to FRESH.
2. Set the air mix mode to MAX COLD.
3. Disconnect the negative battery cable.
4. Remove the following parts:
a. Front doors See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Front Door Removal/Installation
b. Front scuff plate See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate Removal/Installation
c. Front side trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim Removal/Installation
d. Dashboard under cover See: Dashboard Under Cover Removal/Installation
e. Glove compartment See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair
f.
Upper panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Upper Panel Removal/Installation
g. Shift lever knob (MTX) See: Transmission and Drivetrain/Manual Transmission/Transaxle/Shifter M/T/Service and Repair
h. Selector lever knob (ATX) See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and Repair/Automatic
Transaxle Shift Mechanism Removal/Installation
i.
Shift panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Shift Panel Removal/Installation
j.
Side wall See: Side Wall Removal/Installation
k. Console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Console Removal/Installation