3 L4-2.5L (2010)
NOTE:
Apply extra glue (A) on the center and sides of the dashboard.
11. On vehicles equipped with auto A/C, pass the tape of the solar radiation sensor connector (A) through the hole of the new panel (B).
NOTE:
Unlike the original panel, there is no seal tape on the bottom edge of the new panel.
12. Install the new panel on the dashboard, making sure to avoid damaging it.
NOTE:
You may have to remove the foam protective tape cover from the new panel so the tennis balls will stay in place.
13. Remove the paper and masking tape from the windshield installed earlier to prevent it from sticking to the panel.
NOTE:
If glue gets on the dash, remove it immediately with rubbing alcohol.
