3 L4-2.5L (2010)
30. Temporarily tighten the camshaft cap bolts evenly in 2-3 steps.
31. Tighten the camshaft cap bolts in the order shown in the following two steps.
Tightening procedure
-
Step 1: 5.0-9.0 Nm {51-91 kgf-cm, 45-79 in-lbf}
-
Step 2: 14-17 Nm {1.5-1.7 kgf-m, 11-12 ft-lbf
32. Install the OCV. See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Engine Oil Control Valve/Service and Repair
33. Install the exhaust camshaft sprocket bolt, exhaust camshaft sprocket, and a new washer as a single unit.
CAUTION:
-
Install a washer to the fourth or fifth thread of the exhaust camshaft sprocket bolt being careful not to drop the washer.
-
Do not tighten the camshaft sprocket bolt at this stage. Verify the valve timing before performing the bolt tightening.
34. Install the SST on the camshaft as shown in the figure.