3 L4-2.5L (2010)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Campaign MSP23 - PCM Update For MIL/DTC's P2183/P0111
Bulletin No: 01-014/09
Last Issued: 05/07/2009
Subject:
MAZDA SERVICE PROGRAM (MSP23) - MIL ON WITH P2183 AND/OR P0111
BULLETIN NOTE
^ This bulletin supersedes the previous bulletin 01-014/09 issued on 04/29/09. The REPAIR PROCEDURE has been revised.
^ Changes are noted below with [NEW].
APPLICABLE MODEL(S)/VINS
2010 Mazda3 vehicles produced from October 7, 2008 through April 23, 2009
^ VIN Range: JM1BL****A1 100120 - 152216
DESCRIPTION
On some 2010 Mazda3 vehicles, when the engine is started after parking the vehicle under intense sunlight, the malfunction indicator light (MIL) may
illuminate with DTC P2183 (ECT sensor No. 2 circuit range/performance problem) and/or P0111 (IAT sensor circuit range/performance problem) stored
in PCM memory. This is caused by an excessive temperature difference between the ECT # 2, and the IAT due to the sudden rise of engine compartment
temperature from sunlight warming the vehicle's hood. A revised PCM calibration is now available to repair this concern.
NOTE:
^ UNDER THE MAZDA SERVICE PROGRAM (MSP23), ALL CURRENT DEALER INVENTORY AND RETAILED VEHICLES FOUND TO BE
WITHIN THE ABOVE VIN RANGES, AND PRODUCED BETWEEN OCT. 7, 2008 THROUGH APR. 23, 2009, MUST BE INSPECTED AND
REPAIRED ACCORDING TO THE INSTRUCTIONS CONTAINED IN THIS SERVICE BULLETIN.
^ BEFORE PERFORMING ANY REPAIR, VALIDATE THAT THE VEHICLE IS APPLICABLE TO THIS PROGRAM BY PERFORMING AN
"eMDCS WARRANTY VEHICLE INQUIRY" AND VERIFYING THE VEHICLE DISPLAYS CAMPAIGN "MSP23" AND ITS CAMPAIGN
STATUS DISPLAYS "OPEN". SEE "VEHICLE INSPECTION PROCEDURE" BELOW.
DEALER INVENTORY:
Inspect and repair if necessary, all applicable vehicles currently in dealer inventory according to the procedures contained in this service bulletin.
RETAIL VEHICLES:
When an applicable retail vehicle is brought into the dealer for any type of repair or scheduled maintenance, perform an eMDCS Warranty Vehicle
Inspection and check the status of MSP23. If status of MSP23 is "OPEN" inspect and repair if necessary, the vehicle according to the procedures
contained in this service bulletin.
VEHICLE INSPECTION PROCEDURE
1. Verify the vehicle is within the following VIN range and produced between Oct. 7, 2008 through Apr. 23, 2009:
^ 2010 Mazda3
VIN Range: JM1BL****A1 100120 - 152216
-
If the vehicle is within the above VIN range, and produced between Oct. 7, 2008 through Apr. 23, 2009, proceed to Step 2.
-
If the vehicle is not within the above VIN ranges, return the vehicle to the customer or inventory.
