3 L4-2.5L (2010)
2. Perform a Warranty Vehicle Inquiry using your eMDCS System and inspect the vehicle for a Campaign Label MSP23 attached either to the vehicle's
bulkhead or to the vehicle's hood. Refer to eMDCS System - Warranty Vehicle Inquiry Results table above.
NOTE:
Verify the campaign number as the vehicle may have multiple labels.
REPAIR PROCEDURE
1. Verify customer concern.
2. [NEW] Using IDS 60.10 or later software, reprogram the PCM to the latest calibration (refer to Calibration Information table) by following the
Module Reprogramming procedure.
NOTE:
^ Always update the IDS tool first, then follow on-screen instructions to download the needed calibration file for PCM reprogramming.
^ It is not necessary to remove any fuses or relays during PCM reprogramming when the IDS screen prompts you to do so. You may accidentally stop
power to one of the PCM terminals and cause the PCM to be blanked, or you may receive error messages during the IDS reprogramming procedure.
^ IDS shows the calibration part numbers after programming the PCM. Please be aware that PCM calibration part numbers and file names listed in any
Service Bulletin may change due to future releases of IDS software, and additional revisions made to those calibrations for service related concerns.
^ When reprogramming a PCM, IDS will always display the latest calibration P/N available for that vehicle. If any calibration has been revised/updated
to contain new information for a new service concern/issue, it will also contain all previously released calibrations. When performing this procedure,
we recommend that a battery charger be installed on the vehicle battery and turned ON to a maximum charge of no more than 20 AMPS to keep the
vehicle battery up to capacity. If you exceed 20 AMPS, it could damage the VCM.
3. After performing the PCM reprogramming procedure, Clear all CMDTC,s and verify the repair by starting the engine and making sure there are no
MIL illumination or abnormal warning lights present.
NOTE:
^ If any DTCs should remain after performing DTC erase, diagnose the DTCs according to the appropriate Troubleshooting section of the Workshop
