Recall: Emission Harness/Starter Interference Issue
1. Add the rubber pad to the protector clip as shown.
2. Install the protector clip on the emission harness by positioning it on the harness at the point shown (A), then squeeze the clip together until it snaps.
IMPORTANT:
MAKE SURE TO PLACE PROTECTOR CLIP WITH THE FLAT SIDE SHOWING "22" CLOSEST TO THE STARTER CONTACT AREA (B).
PROCEDURE "C" - WATERPROOFING HARNESS
NOTE:
This procedure prevents water entry if harness tape was damaged by engine starter housing contact.
IMPORTANT:
IF VEHICLE IS EXPERIENCING MILS, BLOWN FUSES OR DRIVEABILITY CONCERNS THE EMISSION HARNESS WIRING MAY BE
WORN THROUGH TO BARE COPPER CONDUCTER WIRE AND TOUCHING THE ENGINE STARTER HOUSING.
IS THE VEHICLE CURRENTLY EXPERIENCING MILS, DRIVEABILITY CONCERNS, BLOWN FUSES ETC..?
^ YES - Carefully inspect the emission harness for damage resulting in bare copper wire contact with engine starter housing. If you confirm wires are
shorted, contact the NATIONAL TECHNICAL ASSISTANCE HOTLINE for further instructions.
^ NO - Go to step 1.
NOTE: