3 L4-2.5L (2010)
Fuel Line Coupler: Service and Repair
Quick Release Connector (Emission System) Removal/Installation
QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [LF, L5]
Quick Release Connector Type
CAUTION:
-
There are Three types of quick release connectors. Verify the type and location, and install/remove properly. (LF)
-
There are two types of quick release connectors. Verify the type and location, and install/remove properly. (L5)
Type A Removal
CAUTION:
-
Be careful not to damage the pipe when unlocking the retainer.
NOTE:
-
When removing the quick release connector, either SST 49 E042 001 or 49 N013 103A (Part of 49 N013 1A0D) can be used.
When using SST 49 E042 001
NOTE:
-
If the quick release connector is removed, replace the retainer with a new one.
1. Set the SST parallel to the quick release connector.
NOTE:
-
The quick release connector can be removed by pushing the center of the retainer tabs.
-
The retainer is attached to the pipe even after the connector is disconnected.
