3 L4-2.5L (2010)
Fuel pressure
-
350-430 kPa {3.57-4.38 kgf/cm2, 50.8-62.3 psi}
11. Stop the fuel pump using the following procedure.
Using M-MDS
-
Using the simulation function "FP", stop the fuel pump. See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/On-Board Diagnostic Test
Without using M-MDS
-
Disconnect the negative battery cable to stop the fuel pump.
12. Measure the fuel hold pressure after 5 min.
-
If not within the specification, inspect the following:
-
Fuel line leakage
Fuel hold pressure
-
210 kPa {2.14 kgf/cm2, 30.5 psi} or more
13. Complete the "BEFORE SERVICE PRECAUTION". See: Service Precautions/Vehicle Damage Warnings/Before Service Precaution
14. Disconnect the SST.
15. Connect the quick release connector. See: Fuel Line Coupler/Service and Repair/Quick Release Connector Removal/Installation
16. Complete the "AFTER SERVICE PRECAUTION". See: Service Precautions/Vehicle Damage Warnings/After Service Precaution
