3 L4-2.5L (2010)
CAUTION:
-
Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, or the transaxle may be damaged.
TR switch Installation Note
1. Verify that the manual shaft is aligned with N position.
2. Adjust the TR switch between terminals B and C until the resistance becomes specification.
TR switch specification
-
713-788 ohms
3. Tighten the TR switch installation bolts.
Tightening torque
-
8-11 Nm {82-112 kgf-cm, 71-97 in-lbf}
Manual Shaft Nut Installation Note
1. Set the adjustable wrench as shown to hold the manual shaft lever and tighten the manual shaft nut.
CAUTION:
-
Do not use an impact wrench. Hold the manual shaft lever when installing the manual shaft nut, or the transaxle may be damaged
