3 L4-2.5L (2010)
Input/turbine speed sensor specification
-
250-600 ohms
Intermediate Sensor Inspection - FS5A-EL
INTERMEDIATE SENSOR INSPECTION [FS5A-EL]
On-Vehicle Inspection
1. Inspect the power supply circuit for the intermediate sensor.
a. Set the battery component (ex: battery, battery tray and PCM component) out of the way.
b. Disconnect the intermediate sensor connector.
c. Switch the ignition to ON (engine off).
d. Measure the voltage at intermediate sensor connector terminal A (harness-side).
-
If there is any malfunction, repair wiring harness between intermediate sensor and TCM.
Intermediate sensor specification
-
4.5-5.5 V
e. Switch the ignition to off.
f.
Connect the intermediate sensor connector.
2. Inspect the GND circuit for the intermediate sensor.
a. Switch the ignition to off.
b. Measure the voltage at intermediate sensor connector terminal C (harness-side).
-
If there is any malfunction, repair wiring harness between intermediate sensor and TCM.