3 L4-2.5L (2010)
Gear Sensor/Switch: Service and Repair
Neutral Switch Removal/Installation [G66M-R]
NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R]
1. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
2. Disconnect the negative battery cable.
3. Remove the battery component. (ex: battery, battery tray and PCM component) See: Starting and Charging/Battery/Service and Repair/Removal
and Replacement
4. Remove the aerodynamic under cover No.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
5. Drain the oil from the transaxle. See: Transmission and Drivetrain/Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Transaxle Oil Replacement [G66M-R]
6. Remove the neutral switch.
7. Install the neutral switch (with a new gasket) to the transaxle case.
Tightening torque
-
20-29 Nm {2.1-2.9 kgf-m, 15-21 ft-lbf}
8. Install the battery component. (ex: battery, battery tray and PCM component) See: Starting and Charging/Battery/Service and Repair/Removal and
Replacement
9. Install the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
10. Add the specified amount and type of oil. See: Transmission and Drivetrain/Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Transaxle Oil Replacement [G66M-R]
11. Install the aerodynamic under cover No.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation