3 L4-2.5L (2010)
4. Connect the SST (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the
negative battery terminal.
5. Verify that the red lamp on the SST (Deployment tool) is illuminated.
6. Verify that all persons are standing at least 6 m {20 ft} away from the vehicle.
7. Press the activation switch on the SST (Deployment tool) to operate (deploy) the pre-tensioner seat belt.
WARNING:
-
The pre-tensioner seat belt is very hot immediately after it is operated (deployed). You can be burned. Do not touch the pre-tensioner seat belt
for at least 15 min after deployment.
8. Disconnect the SST (Deployment tool) from the SST (Adapter harness).
Deployment Procedure for Outside of Vehicle
1. Inspect the SST (Deployment tool). See: Tools and Equipment
2. Switch the ignition to off.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Follow the procedure below for operating (deploying) the applicable air bag module or lap pre-tensioner seat belt.
Part 2
AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES
WARNING:
-
A live (undeployed) air bag module or pre-tensioner seat belt may accidentally operate (deploy) when it is disposed of and cause serious injury.
Do not dispose of a live (undeployed) air bag module and pre-tensioner seat belt. If the SSTs (Deployment tool and Adapter harness) are not
available, consult the nearest Mazda representative for assistance.
CAUTION:
-
Deploying the air bag modules and pre-tensioner seat belts inside the vehicle may cause damage to the vehicle interior. When the vehicle is not to
be scrapped, always deploy the air bag modules and pre-tensioner seat belts outside the vehicle.
-
If the vehicle is to be scrapped, or when disposing of any air bag modules or pre-tensioner seat belts, operate (deploy) them inside the vehicle by
following the deployment procedure below and using the SST (Deployment tool).
-
When disposing of an operated (deployed) air bag module and pre-tensioner seat belt, refer to "AIR BAG MODULE AND PRE-TENSIONER
SEAT BELT DISPOSAL PROCEDURES".
Driver-side Air Bag Module
