3 L4-2.5L (2010)
8. Connect the SST (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the
negative battery terminal.
9. Verify that the red lamp on the SST (Deployment tool) is illuminated.
10. Verify that all persons are standing at least 6 m {20 ft} away from the vehicle.
11. Press the activation switch on the SST (Deployment tool) connected with 49 L066 002 (a yellow connector) of the SST (Adapter harness), and
after 3 s, press the activation switch on the other SST (Deployment tool) to operate (deploy) the air bag module (both inflators).
WARNING:
-
Verify that air bag module operation (explosive) sound occurs twice. If no operation (explosive) sound was heard or a single operation
(explosive) sound was heard, both inflators would not have operated (deployed) properly. This may cause serious injury if the air bag module
operates (deploy) unexpectedly. If the two operation (explosive) sounds are not heard, perform Step 11 again. If a total of two operation
(explosive) sounds cannot be verified even though Step 11 is performed again, leave the air bag module alone for 30 min or more before
approaching it again.
-
The air bag module is very hot immediately after it is operated (deployed). You can be burned. Do not touch the air bag module for at least 15
min after deployment.
12. Disconnect the SST (Deployment tool) from the SST (Adapter harness).
Side Air Bag Module
1. Remove the front seat. See: Body and Frame/Seats/Service and Repair/Removal and Replacement
2. Remove the front seat back trim and pad. See: Body and Frame/Seats/Seat Back/Service and Repair/Front Seat Back Trim Removal/Installation
3. Remove the side air bag module. See: Removal and Replacement/Side Air Bag Module Removal/Installation
4. Connect the SST (Adapter harness) to the side air bag module as shown in the figure.
5. Put the side air bag module inside the tire and secure it to the tire by wrapping a wire (cross section of 1.25 mm2 {0.002 in2} or more) through
the tire and the bolt at least 4 times.
