mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Procedures|Page 5889 > < Procedures|Page 5887
Page 7
background image

17. Pull hook C in the direction shown in the figure and remove it from the body.

18. Remove the curtain air bag module.

19. Install in the reverse order of removal.

20. When the switch the ignition to ON verify that the air bag system warning light illuminates for approx. 6 s and goes out. 

-

If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection
of the system.  See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Flowchart

5HB

1. Switch the ignition to off.

2. Disconnect the negative battery cable and wait for 1 min or more.

3. Partially peel back the seaming welt.

4. Remove the rain sensor cover. (Vehicles with auto light/wiper system) (See  See: Sensors and Switches/Sensors and Switches - Wiper and Washer

Systems/Rain Sensor/Service and Repair)

5. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system)

6. Remove the following parts: 

a. Sunroof seaming welt (vehicles with sunroof system)

b. A-pillar trim  See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/A-Pillar Trim Removal/Installation

c. Front scuff plate  See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate Removal/Installation

d. Rear scuff plate  See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Rear Scuff Plate Removal/Installation

e. B-pillar lower trim  See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Lower Trim Removal/Installation

f.

Upper anchor of the front seat belt  See: Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Belt Removal/Installation

g. B-pillar upper trim  See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Upper Trim Removal/Installation

h. Rear seat cushion  See: Body and Frame/Seats/Seat Cushion/Service and Repair/Rear Seat Cushion Removal/Installation

i.

Tire house trim  See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Tire House Trim Removal/Installation

j.

Trunk side upper trim  

k. C-pillar trim  See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/C-Pillar Trim Removal/Installation

l.

Map light  See: Lighting and Horns/Map Light/Service and Repair/Map Light Removal/Installation

m. Interior light  See: Lighting and Horns/Courtesy Lamp/Service and Repair/Interior Light Removal/Installation

n. Sunvisor  See: Body and Frame/Interior Moulding / Trim/Sun Visor/Service and Repair

o. Assist handle  See: Body and Frame/Interior Moulding / Trim/Passenger Assist Handle/Service and Repair

p. Headliner  See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair

7. Remove the fastener.

Procedures|Page 5889 > < Procedures|Page 5887