3 L4-2.5L (2010)
12. Pull hook A in the direction shown in the figure and remove it from the body.
13. Remove the clip B.
14. Remove the bolt B.
15. Pull hook B in the direction shown in the figure and remove it from the body.
16. Remove the clip C.
17. Remove the bolt C.
18. Pull hook C in the direction shown in the figure and remove it from the body.
19. Remove the curtain air bag module.
20. Install in the reverse order of removal.
21. When the switch the ignition to ON verify that the air bag system warning light illuminates for approx 6 s and goes out.
-
If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection
of the system. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Flowchart
Clip Removal Note
1. Pull out the pin with flathead screwdriver as shown in the figure.
2. Insert a flathead screwdriver into shown in the figure.
