3 L4-2.5L (2010)
5. Install the pre-tensioner seat belt.
6. Connect the SST (Deployment tool) to the SST (Adapter harness).
7. Connect the SST (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the
negative battery terminal.
8. Verify that the red lamp on the SST (Deployment tool) is illuminated.
9. Verify that all persons are standing at least 6 m {20 ft} away from the vehicle.
10. Press the activation switch on the SST (Deployment tool) to operate (deploy) the pre-tensioner seat belt.
WARNING:
-
The pre-tensioner seat belt is very hot immediately after it is operated (deployed). You can be burned. Do not touch the pre-tensioner seat belt
for at least 15 min after deployment.
11. Disconnect the SST (Deployment tool) from the SST (Adapter harness).
Lap pre-tensioner Seat Belt
1. Remove the lap pre-tensioner seat belt and connect the SST (Adapter harness) as shown in the figure. See: Seat Belt/Service and Repair/Front
Seat Belt Removal/Installation
2. Install the lap pre-tensioner seat belt.
3. Connect the SST (Deployment tool) to the SST (Adapter harness).